Home / Resources / Revenue Cycle Benchmarks: Collection Rate and Cost to Collect

Guide

Revenue Cycle Benchmarks: Collection Rate and Cost to Collect

How to calculate the main revenue cycle numbers, and how to judge them without chasing someone else's average.

Updated October 2026

The main revenue cycle benchmarks are net collection rate (payments divided by what you were entitled to collect), cost to collect (the cost of billing divided by collections), clean claim rate, denial rate and days in A/R. Benchmarks vary by specialty and payer mix, so the most useful comparison is your own numbers over time, checked against ranges commonly cited by industry sources.

The core measures and how to calculate them

MeasureFormulaCommonly cited direction
Net collection ratePayments divided by (charges minus contractual adjustments)Often cited in the mid-to-high 90 percent range. Higher is better
Gross collection ratePayments divided by total chargesLower than net, and depends on your fee schedule, so compare with your own past numbers
Cost to collectTotal cost of billing (staff, software, fees, or outsourcing) divided by total collectionsLower is better. Compare it with an outsourced quote
Clean claim rateClaims accepted on first submission divided by claims submittedOften cited at 95 percent or higher
First-pass denial rateClaims denied on first submission divided by claims submittedOften cited under about 5 percent
Days in A/RTotal A/R divided by average daily chargesMany practices aim for roughly 30 to 40 days
A/R over 90 daysA/R older than 90 days divided by total A/ROften cited under about 15 percent

These ranges are general figures that industry sources often cite. They vary by specialty, payer mix and how a source defines each measure, so use them as a rough guide, not a target set for you.

Net versus gross collection rate

The net collection rate removes contractual adjustments, which you cannot collect, so it shows how well you collect what you are entitled to. The gross rate compares payments with full charges and moves with your fee schedule, so it says less about performance.

Cost to collect

  1. Add up the full cost of billing for a period: wages and benefits, software and clearinghouse fees, training, and any outsourcing fees.
  2. Divide by total collections for the same period.
  3. Compare with the cost of an outsourced quote using your own numbers. See how much does medical billing cost?

How to benchmark yourself

  1. Start with your own trend. Calculate each measure monthly for the last 12 months.
  2. Look at it by payer. An average can hide one payer that is much slower or denies much more.
  3. Compare with a source in your specialty, such as data published by a professional association, and note how it defines each measure.
  4. Find the largest gap first. Work the measure where the money at stake is greatest.
  5. Recheck monthly and record what you changed.

Use the numbers

Try the free denial and A/R calculator with your own figures. For definitions of each measure, see key RCM metrics and what is A/R in medical billing. If your numbers show a gap, request a free billing audit. This guide is general information. Benchmarks vary by source, specialty and payer mix.

Frequently asked questions

What is a good net collection rate?

Sources often cite the mid-to-high 90 percent range, but it varies by specialty and payer mix. Track your own trend and compare it by payer.

How do I calculate cost to collect?

Divide the total cost of billing for a period, including staff, software, fees and outsourcing, by total collections for the same period.

Are industry benchmarks reliable?

They are a rough guide. Sources define measures differently and use different samples, so your own trend and payer-level numbers matter more.

Ready to see what your billing could look like?

Tell us about your practice and we will review how your billing runs today and where it can improve. No patient information needed.